Electrolux 1458528 User Manual page 10

6 ice and water installation electrolux side by side refrigeration
Installing your Ice and Water Filter
Step 8
Push shorter tube into tap fitting past insertion mark.
Step 9
Push other end into filter INLET.
water
flow
direction
Step10
Connect remaining tube length to filter OUTLET.
Step 11
Connect other end of remaining tube length to inlet on
bottom right hand side of refrigerator back.
INLET LOCATION
inlet location
Step 12
Turn on water and check all joints and tubes for leaks.
Step 13
Reconnect the power.
Step 14
Move the refrigerator back into place being careful not to
kink or split the tubing.
Step 15
Using a large container run the water dispenser to clear
air from lines. This may take a few minutes. Purge and
dispense a minimum of 2 litres of water. Initial water may
be black in colour. This is residual carbon dust from the
filter and is non-toxic. If the water is slow to shut off or
the dispenser is dripping, air may still be in the lines.
Either purge more water through the system to remove
this air or allow some time for the air to be removed over
subsequent dispensing.