Installing Your Ice And Water Filter - Electrolux 1458528 User Manual

Installing your Ice and Water Filter

Never install the water filter in an area of direct sunlight.
Check for water leaks at all water connection points in the
first 2 to 3 hours after installation, and correct it in case of
any water leak. Recheck after 24 hours; if leak still occurs, it
is recommended to contact a licensed plumber for advice.
Installation
Water is to be connected as per diagram below.
Step 1
Remove ice cream shelf (in freezer) and ensure that the Ice
maker is switched OFF
sink
brackets
mains
water inlet
1/2"
tap fitting
kitchen
cupboard
Step 2
Disconnect the refrigerator from the power supply.
ICE MAKER ON OFF SWITCH
OFF ON TEST
FOR SERVICE
USE ONLY.
HOLD DOWN
FOR 15 SECS.
Step 3
Connect tap fitting to water supply tap. Tap must be close
to the refrigerator.
electrolux side by side refrigeration ice and water installation 5
Step 4
Install the brackets within 1 metre from the water supply
tap, in a vertical orientation where possible, using the
screws provided.
Do not screw the brackets into the refrigerator as this
may void your warranty and permanently damage the
refrigerator.
Step 5
Write date on filter. The filter will need to be replaced every
12 months.
Step 6
Extend the red collar and clip a circlip around the collar at
both ends of the filter.
Step 7
Fit filter to brackets with water flow arrow pointing up.