D-Link Vonage Quick Start Manual page 6

7.
Now plug your Modem's power cord back into an electrical
power outlet.
NOTE: You should allow enough time for your Modem to complete its
start-up process. If you're unsure about how long this takes, consult
the manual that came with your Modem. Typical Modem start-up takes
60 seconds.
8.
Next, using the Power Cord that came with your Vonage kit,
plug the smaller end of the Power Cord into the circular
Power Port on the back of the Vonage Device. Then, plug the
larger end of the Power Cord into an electrical power outlet.
NOTE: Before continuing, the "Power" and "Internet" lights on the front
of the Vonage Device should both turn on. Wait until the "Power" light
stops blinking and both "Power" and "Phone 1" lights are solid. The
"Phone 2" light will be solid if you have a second Vonage line. Otherwise,
it will not light. The "Internet" light will flicker whenever there is
communication activity.
9.
Now turn on your computer, open your web browser and
check your Internet connection by visiting any website.
NOTE: After turning on your computer, the Ethernet light on the Vonage
Device will also flicker whenever there is communication activity.
• If your Internet connection works,
go to Step 4: Connect Your Phone, on page 14.
8
If your Internet connection doesn't work and
you have a Cable Modem:
1.
2.
If your Internet connection doesn't work and
you have a DSL modem:
1.
Vonage Device
2.
3.
4.
5.
6.
7.
Unplug the Modem for at least 10 minutes. If left off for less
than 10 minutes, it might still "remember" old information
that could prevent it from working properly.
If your Internet connection still does not work, you may
need to register your Vonage Device with your cable
provider. You will need the WAN MAC ID on the bottom
of the Vonage Device.
On your computer, open a Web browser. In the Address
field, type http://192.168.15.1 (the default IP address
of the VWR Home Page) and press Enter. A login
window appears.
In both the Username and Password fields, type 'user'
and click login. The HOME page is displayed.
(Perform this step only if your existing setup did NOT
include a router.) In the Home tab, make sure WAN is
selected on the left hand side.
Under Internet Settings, select PPPoE IP Address.
In the Username and Password fields, type the username
and password you normally use to log in to your DSL service.
In the Keep Alive field, type 0 to ensure that your DSL link is
always active.
Click Connect to start your Internet connection. Click Apply.
Click Save and Restart button on the left and click Reboot.
9