D-Link Vonage Quick Start Manual page 7

Step 3:
Set up your Vonage Device
(with existing Modem and Router or
Modem with Built-In Router)
1.
Shut down your computer and unplug your existing
Modem and Router power cords.
2.
Attach the antenna to your Vonage Device.
3.
Locate an unused Ethernet port on your existing router.
4.
Connect one end of the blue cable
on your router. Connect the other end to the
labeled "Internet" on the back of the Vonage Device.
NOTE: The ports on the back of your existing router may be labeled
"Ethernet" or "LAN" and may be numbered 1-4. You can plug the
Blue Cable into any of these ports.
Existing Router
10
to the Ethernet port
blue port
Vonage Device
If all the Ethernet ports on your existing
router are in use,
disconnect one of the cables
in the Ethernet or LAN ports from your existing
router. Connect that cable to the
labeled "Ethernet" on the Vonage Device.
Then connect one end of the blue cable
port labeled "Internet" on the back of the Vonage
Device. Connect the other end of the
the port you just made available on your router.
NOTE: If you don't have any available ports on your router
and you have a home network set up (where you share files
on computers or share a printer), then you should install the
Vonage device in front of your existing router. Please see
www.vonage.com/homenetwork for instructions.
5.
Now plug your modem's power cord back into an
electrical power outlet.
NOTE: You should allow enough time for your Modem to complete
its start-up process. If you're unsure about how long this takes,
consult the manual that came with your Modem. Typical Modem
start-up takes 60 seconds.
yellow port
to the blue
blue cable to
11