Cutterhead Guard - Porter-Cable PC160JT Instruction Manual

11
L
13
15
A
B
5. Position fence (L) Fig. 11 so that rounded section (M) on
bottom of fence is over cutterhead opening.
6. Tighten two screws (G) Fig. 12 using included hex
wrench.

CUTTERHEAD gUARD

1. Locate the two M6x1x12 mm button head screws (A) Fig.
13 in front side of jointer base. MAKE SURE THEY ARE
NOT COMPLETELY TIgHTENED AT THIS TIME.
2. Slide cuttinghead guard's mounting bracket (B) Fig. 14
onto the two screws (A). Make sure cutterhead guard is
touching the fence and tighten the two screws (A).
CUTTERHEAD LOCK
Assemble cutterhead lock (A) Fig. 15 to the front side of the
jointer base, using the M6x1x12 mm button head screw (B).
NOTE: The cutterhead lock (A) is to be engaged with the
cutterhead shaft (Fig. 15) Only when setting knives. All other
times, the cutterhead lock (A) should be disengaged from the
cutterhead (Fig. 16).
FASTENINg JOINTER TO SUPPORTINg SURFACE
If during operation, there is any tendency for the jointer to tip
over, slide or "walk" on the supporting surface, the jointer must
be secured to the supporting surface. Four holes (two of which
are shown at (R) Fig. 20), are provided for this purpose.
M
A
fr
sp
12
g
14
16
V
20
R
S
VACUUM HOSE ADAPTER
A vacuum hose adapter (V) Fig. 20 is supplied with the jointer to
help connect it to a standard 2 inch vacuum hose. To assemble
the adapter:
1. Remove two screws (S) Fig. 20. Loosen screws (T).
2. Slide adaptor's slots (U) under loosened screws (T).
3. Tighten screws (T) when adaptor (V) is in proper location.
4. Replace and tighten screws (S).
NOTICE
Do not install this dust chute unless you will be
using a dust collector.
AVIS
AVISO
7
A
B
A
T
g
A
U
R