Restarting; Warning Message - Mercedes-Benz SLS AMG Operator's Manual

Tire pressure monitor warning mes-
sages
If the tire pressure monitor detects a pressure
loss in one or more tires, a warning message
is shown in the multifunction display and the
yellow tire pressure monitor warning lamp
comes on.
If the Correct Tire Pressure Correct Tire Pressure
R
appears in the multifunction display, the
tire pressure in at least one tire is too low
and must be corrected at the next oppor-
tunity.
If the Check Tire Pressure Check Tire Pressure
R
appears in the multifunction display, the
tire pressure in one or more tires has drop-
ped significantly and the tires must be
checked.
If the Tire Pressure Warning Tire Tire Pressure Warning Tire
R
Malfunction Malfunction message appears in the mul-
tifunction display, the tire pressure in one
or more tires has dropped suddenly and the
tires must be checked.
Observe the instructions and safety notes in
the display messages in the "Tires" section
( page 182).
Y
i
If the wheel positions on the vehicle are
rotated, the tire pressures may be dis-
played for the wrong positions for a short
time. This is rectified after a few minutes of
driving, and the tire pressures are displayed
for the correct positions.
Restarting the tire pressure monitor
When you restart the tire pressure monitor, all
existing warning messages are deleted and
the warning lamps go out. The monitor uses
the currently set tire pressures as the refer-
ence values for monitoring. In most cases, the
tire pressure monitor will automatically
detect the new reference values after you
have changed the tire pressure. However, you
can also define reference values manually as
described here. The tire pressure monitor
then monitors the new tire pressure values.
Set the tire pressure to the value recom-
X
mended for the corresponding driving sit-
uation on the Tire and Loading Information
placard on the driver's side
B-pillar (
Additional tire pressure values for different
loads can also be found on the tire pressure
table on the inside of the fuel filler flap
message
( page 253).
Y
Make sure that the tire pressure is correct
X
on all four wheels.
Make sure that the SmartKey is in position
X
2 in the ignition lock.
message
Press the = or ; button on the steer-
X
ing wheel to select the
Press the 9 or : button to select
X
Tire Tire Pressure
Press the a button.
X
The multifunction display shows the cur-
rent tire pressure for the individual tires or
the
after driving a few minutes after driving a few minutes
sage.
Press the : button.
X
The
Reference Values Reference Values
the multifunction display.
If you wish to confirm the restart:
Press the a button.
X
The
message appears in the multifunction dis-
play.
After driving for a few minutes, the system
checks whether the current tire pressures
are within the specified range. The new tire
pressures are then accepted as reference
values and monitored.
If you wish to cancel the restart:
Press the % button.
X
The tire pressure values stored at the last
restart will continue to be monitored.
Tire pressure
page 253).
Y
Serv. Serv.
Pressure.
Tire pressure Tire pressure will will be be displayed
Use Current Pressures as New Use Current Pressures as New
message appears in
Tire Press. Monitor Restarted Tire Press. Monitor Restarted
259
menu.
displayed
mes-
Z