Mercedes-Benz SLS AMG Operator's Manual page 173

Display messages
Possible causes/consequences and M M Solutions
Make sure that there are no objects on the seat adding to the
X
weight.
The system may otherwise detect the additional weight and
interpret the seat occupant's weight as greater than it actually
is.
Keep the seat unoccupied, close the front-passenger door and
X
switch on the ignition.
Observe the 45(
function display and check the following:
Seat unoccupied and ignition switched on:
the 45 indicator lamp must light up and remain lit. If the
R
indicator lamp is on, OCS (
passenger air bag.
the Front Passenger Airbag Enabled See Operator's Front Passenger Airbag Enabled See Operator's
R
Manual Manual or Front Passenger Airbag Disabled See Oper‐ Front Passenger Airbag Disabled See Oper‐
ator's Manual ator's Manual display messages must not be shown in the
multifunction display. Wait for a period of at least 60 seconds
until the necessary system checks have been completed. This is
necessary to make sure that the display messages do not
appear in the multifunction display.
If these conditions are fulfilled, the front-passenger seat can be
occupied again. Whether the 45 indicator lamp remains lit
or goes out depends on how OCS classifies the occupant.
If the conditions are not fulfilled, the system is not operating cor-
rectly.
Visit a qualified specialist workshop immediately.
X
For further information about the Occupant Classification System,
see ( page 42).
Y
Display messages
page 42) indicator lamp and the multi-
Y
page 42) has disabled the front-
Y
171
Z