Installation - Kenwood DPX503 Instruction Manual

Installation
Installing the Unit
Bend the tabs of the mounting sleeve with
a screwdriver or similar utensil and attach it
in place.
Installing in Japanese-Made Cars and
General Motors Cars
Install onto the car bracket using the supplied screws
(MS x 6 mm, MS x 7 mm),
The holes of the car bracket to use will differ
depending on the car model.
Car Bracket
Accessory@ (MS x 7 mm)
or Accessory@(MS x 6 mm)
34
I DPXS03/DPX303
Removing the hard rubber frame
1
Engage the catch pins on the removal tool and
remove the two locks on the upper level.
Upper the frame and pull it forward as shown in
the figure.
2
When the upper level is removed, remove the
lower two locations.
Q
~
• The frame can be removed from the bottom side in the
same manner.
Removing the Unit
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Insert the two removal tools deeply into the slots
on each side, as shown.
3
Lower the removal tool toward the bottom, and
pullout the unit halfway while pressing towards
the inside.
~
• Be careful to avoid injury from the catch pins on the
removal tool.
4
Pull the unit all the way out with your hands, being
careful not to drop it.