Kenwood DPX503 Instruction Manual page 21

Function of DPX503
Manual position setting
Function of DPX503
Audio Preset Memory
Making fine adjustment of the value specified at
Preset position selection per speaker.
Registering the value setup by Sound Control. The
memory cannot be erased by the Reset button.
• When you select "USER" at <Preset position selection>
(page 20), the adjusted setting value will be recalled.
1
Enter Position setting mode
Select "SOUND" > "S-CTRl"> "POSIT" >
"M-POSI'~
For how to select Function Control item, refer to
<Function Control> (page 6).
2
Select the speaker you want to adjust
Turn the Control knob and push the center
when the desired item is displayed.
3
Adjust the speaker
Turn the Control knob.
Adjust between 0 and 5.58 feet.
4
Exit Position setting mode
Press the [FNCl button.
~
~
• Register 1 pair of Audio Preset Memory. You cannot
register by the source.
• When you press the Reset, all the sources will be the
setting value which is registered.
1
Setup Sound Control
Refer to the following operations to setup the
Sound Control.
- Cabin selection (page 19)
- DTA (Digital Time Alignment) setting (page 19)
- X'Over setting (page 20)
- Equalizer Control (page 20)
- Preset position selection (page 20)
- Manual position setting (page 21)
2
Enter Audio Preset Memory mode
Select "SOUND" > "PRESET" >
"MEMO'~
For how to select Function Control item, refer to
<Function Control> (page 6).
3
Put the Audio Preset in the memory
Press the Control knob.
"Memory?" is displayed.
4
Turn the Control knob to select
"YES'~
and then
press the Control knob.
"Memory Completed" is displayed.
5
Exit Audio Preset mode
Press the [FNC] button.
(§]
Subwoofer Left
Subwoofer Right
Rear Right speaker
Rear Left speaker
Front Left speaker
Front Right speaker
"Sub Rch"
"Sub Lch"
"Front Lch"
"Front Rch"
"Rear Lch"
"Rear Rch"
English I
21