Kenwood DPX503 Instruction Manual page 23

Audio Setup
You can set Sound system
I
such as follows;
Rear High Pass Filter* "HPF-R"
Low Pass Filter* "LPF"
Subwoofer Phase* "SW PHASE"
Volume offset "VOL-OFFSET"
Loudness* "LOUD"
- - - , - - -
Dual
lone
System "2 lONE"
*Function of DPX303.
Q
~
• Volume offset: Sets each source's volume as a difference
from the basic volume.
• Loudness: Compensates for low and high tones during
low volume. (Only the low tone is compensated for
when the tuner is selected as a source.)
Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by "Zone2" of
<Function Control> (page 6).
- Select Main source by [SRC) button.
- Adjust the volume of Front channel by [AUD) knob.
- Adjust the volume of Rear channel by <Audio Control>
(page 22) or [.. )I[T] button on the remote control
(page 27).
- The Audio Control has no effect on sub source.
1 Select the source to adjust
For how to select source item, refer to <Power/
Source Select button> of <Basic Operation> (page
4).
2
Enter Audio Setup mode
Press the [AUD] knob for at least
1
second.
3
Select the Audio Setup item to adjust
Press the [AUD] knob.
4
Adjust the Audio setup item
Turn the [AUD] knob.
S
Exit Audio Setup mode
Press the [AUD] knob for at least 1 second.
Speaker Setting
Fine-tuning so that the System
Q
value is optimal
when setting the speaker type as follows;
OFF "OFF"
- - - - - - - -
For 5 & 4in. speaker "S/4inch"
-::---:-::---:-:--'---,----
For 6&6x9 in. speaker "6x9/6inch"
-=-Fo' - -r-' : - t h -' - -e""'OE:-M-s-pe"-:ak'--er-'----- "O.E.M:'
- - - - - - - - - -
1
Enter Standby
Select the "STANDBY" display.
For how to select source item, refer to <Power/
Source Select button> of <Basic Operation> (page
4).
2
Enter Speaker Setting mode
Press the [AUD] knob.
"SP SEL" is displayed.
3
Select the Speaker type
Turn the [AUD] knob.
4
Exit Speaker Setting mode
Press the [AUD] knob.
English I
23