Table of Contents
Advertisement
AUTO PUNCH IN / OUT
Auto Punch allows you to Overdub or Record automatically between 2 preset points. This can be
very useful at times such as when you want to execute a very tight punch-in and there isn't enough
time to get from the MPC2000XL to the MIDI keyboard to play the new notes after the punch-in.
The Auto Punch function allows you to punch in automatically, allowing you to concentrate on your
performance.
Hold SHIFT and press MISC. (2 on the numeric pad).
Auto
Auto punch:
PUNCH
•
Auto punch:
There are three auto punch modes:
PUNCH IN ONLY
PUNCH OUT ONLY
PUNCH IN OUT
•
IN
Sets the auto punch in point.
•
OUT
Sets the auto punch out point.
To start auto punch, press TurnON [F6]. The display returns to the Main Screen and is now in
standby mode.
Sq:01-(Sequence01)
.......................................................
™:120.0(MAS)
Count:OFF
..................................................................................................
Tr:01-(Unused)
S:DRUM1:OFF New Pgm-A
Auto punch function is active!!
Auto punch function is active!!
While holding REC or OVERDUB, press PLAY or PLAY START to start recording.
Punch in or out will automatically start at the set point and enable you to record your performance.
To cancel auto punch, press OFF [F6] and return to the normal Main Screen.
punch:PUNCH IN ONLY
PUNCH IN ONLY
IN
Time:001.01.00
TRANS 2ndSEQ
This allows you to automatically punch in only. To stop the
recording, press STOP.
This allows you to automatically punch out only. To start
recording, press PLAY or PLAY START while holding down
REC or OVER DUB.
Both punch-in and punch-out are executed automatically.
Timing:1/16
Loop:OFF
New Pgm-A
Page 60
Chapter 3: Recording Sequences
TurnON
Now:001.01.00
Tsig: 4/ 4
Tsig: 4/ 4
Bars: 2
Bars: 2
ON:YES
Pgm:OFF
Velo%:100
OFF
Advertisement
Table of Contents
