Reversible Door - Vintec V 150 SG2E Instructions For Use Manual

Reversible door

The door can be changed from right-hinged to left-hinged and vice versa as follows:
1. Lay the appliance on its back and loosen
the upper hinge.
4. Carefully remove the covers on the
side of the plinth using a fl at-headed
screwdriver.
7. When the lock pin has been loosened
completely, pull it up together with the
lock cylinder and refi t on opposite side.
10. After reversing the door, it is important to check that the sealing strip provides a tight seal all the way round. If it does not, carefully heat
the strip all the way round using a hair dryer. Then ease the strip outwards slightly so that it forms a tight seal against the cabinet. Be
careful not to heat the strip so much that it melts!
2. Remove the upper hinge.
5. Pull up the hinge pin...
...and fi t it on the opposite side.
8. Click the covers into place on the plinth
sides on the opposite side.
7
3. Rotate the glass door through 180° (on
V 150 SG2E, pull the handle to loosen
it on the inside from beneath the sealing
strip).
6. Unscrew the lock pin using a fl at-headed
screwdriver.
9. Fit the door onto the bottom pin, fi t the
top hinge and tighten securely.
GB