Advertisement
Advertisement
Related Manuals for Vintec V 150 SG2E
Summary of Contents for Vintec V 150 SG2E
- Page 1 V 150 SG2E / V 190 SG2E Instructions for use...
-
Page 2: Table Of Contents
Thank you for purchasing your new wine you of how collection and recycling of such cooler from Vintec. Please note that these units take place in your area. instructions apply to all wine coolers in the Vintec range. Illustrations and fi ttings... -
Page 3: Get To Know Your Wine Cooler
Get to know your wine cooler Lighting Charcoal fi lter Wooden shelf Sealing strip Nameplate Door handle Kick plate Control panel Lock Adjustable feet fi g.1... -
Page 4: Installation And Start-Up
Installation and start-up Placement For safety and operational reasons, the appliance must not be installed outdoors. The appliance should be placed on a level surface in a dry, well ventilated room (max. 75% relative air humidity). Never place the appliance close to sources of heat such as cookers or radiators, and avoid placing it in direct sunlight. - Page 5 The appliance viewed from The appliance viewed from Ventilation It is important that the appliance be above well ventilated and that air can circulate If the appliance is placed beside a wall, unhindered above, below and around it. there must be suffi cient room for its door The fi...
- Page 6 Setting up It is important that the appliance be absolutely level. It can be levelled by screwing the adjustable feet at the front of the appliance up or down (fi gs 8-9). Use a spirit level to check that the appliance is absolutely level sideways.
-
Page 7: Reversible Door
2. Remove the upper hinge. 3. Rotate the glass door through 180° (on the upper hinge. V 150 SG2E, pull the handle to loosen it on the inside from beneath the sealing strip). 4. Carefully remove the covers on the 5. -
Page 8: Electrical Connection
Electrical connection The appliance is intended for connection to alternating current. The required volt- age (V) and frequency (Hz) are stated on the nameplate inside the appliance. Power must be connected via an independent wall socket outlet. If the mains lead has been damaged, it must be replaced with a corresponding type supplied by the manufacturer or an approved service centre. -
Page 9: Operation And Function
Operation and function Light switch On/off switch fi g. 9 Electronic controls temperature display has a built-in fi lter that simulates the actual temperature in The electronic controls ensure that the set the bottles. The displayed temperature temperatures are maintained at the top and is therefore not affected by transient bottom of the cabinet. - Page 10 Low-temperature alarm If the temperature has been below 2°C for more than 1 hour, the display fl ashes and Lo/actual temperature are alternately shown. Wine cannot mature properly at sub-zero temperatures. Two-zone setting for serving temperature Typical serving temperature settings for the top and bottom sections are 16°C and 6°C respectively.
-
Page 11: Defrosting, Cleaning And Maintenance
Defrosting, cleaning and maintenance Automatic defrosting Automatic defrosting Replacing the light tube The wine cooler is defrosted automatically. Disconnect the power by pressing the on/off Defrost water runs through a pipe and is button. Remove the lamp cover using a collected in a tray above the compressor small fl... -
Page 12: Fault Fi Nding
Fault fi nding Fault Possible cause Remedy The appliance is The appliance is switched off. Press the on/off switch. “dead”! Power failure; the fuse is blown; Check that power is connected. the appliance is not plugged in Reset the fuse. correctly.