Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Vintec V30SG
Summary of Contents for Vintec V30SG
- Page 2 The information in this document is subject to modification without any prior notice Important: All models without front venting (air opening) are strictly for free standing only. ( see technical chart)
- Page 3 In locations where there is frequent lightning, it is advisable to use surge protectors.
- Page 4 Important: If the unit is unplugged, power is lost, or turned off, wait 3 to 5 minutes before restarting the unit. The wine cellar will not start if you attempt to restart before this time delay.
- Page 5 An individual’s perception of noise is directly linked to the environment in which the wine cellar is located, as well the specific type of models. VINTEC wine cellars are in line with international standards for such appliance. VINTEC will always do its utmost to satisfy its customers but will not retake possession of the goods due to complaints based on normal operating noise occurrences.
-
Page 7: Temperature Settings
Important: The LCD displays by default the actual internal air temperature. It is important to understand that there is a difference between the air temperature inside the wine cellar and the actual temperature of the wine:... - Page 11 The water collected by condensation, is therefore recycled. Under extremely dry environmental conditions, you may have to add some water into the water container provided with your wine cellar During the refrigerating cycle, heat is given off and disperse through the external surfaces of the wine cellar.
- Page 15 （...
- Page 16 ， ；...
- Page 17 (85mm recess plinth)
- Page 20 Any intervention performed by a non-technician will lead to the warranty being considered as null and void.
- Page 22 ： ： ： ：...
- Page 24 ： ： ： ：...
- Page 25 • • • • • • • •...
Need help?
Do you have a question about the V30SG and is the answer not in the manual?
Questions and answers
We have a Virtec Model 160SP and wish to adjust the temperature. how do we adjust the temperature/ At present it shows 0 C degrees.
To adjust the temperature on a Vintec V30SG electronic model:
1. Press the UP or DOWN buttons on the control panel.
2. The "TEMP. SET LED" will show the set temperature.
3. The "DISPLAY LED" shows the current internal air temperature.
Adjust until the desired cooling temperature is shown on the "TEMP. SET LED".
This answer is automatically generated