Setup Menu - Velleman Personal Scope HPS10 User Manual

_________________________________________________________________________________________________________________________________________________________
Fig 12
•
A dot grid divides the screen into reference points. (Fig. 11)
•
A full grid divides the screen into reference lines.(Fig. 12)
•
Markers: Moveable markers in order to measure the signal (Fig. 13).
•
A cross inserts a coordinate system into the screen. (Just for HPS10)
G
Notes:
•
The number of readout-digits depends on the selected display layout.
•
At dynamic display mode (see display setup), the display layout changes for best fitting by shifting the
markers or x-position.
•
When no markers are displayed, the cursor keys are set for changing the time base or input sensitivity
when no keys are pressed during 10 seconds.
•
Markers can also be accessed directly by pressing the 'Marker 1-2' key.
Display

SETUP MENU

Setup
Long press: Shows a setup menu for changing the operation mode, the default power-off timer, the
display mode (and RS232 transmit setup è Only for HPS40).
1. Select the highlighted item with a short keypress of the setup-key and the cursor keys.
2. Keep the setup-key pressed to exit the setup-menu and to apply the selections.
G
Note:
•
A Checkmark indicates the current selection.
•
Leaving the mode menu with the 'power off' key will cancel the selection.
•
If no key is pressed during 10 seconds, the selection will be cancelled; the unit returns to it previous operating
mode and the cursor keys are set for changing the time base or input sensitivity.
1. Operating mode
1
Fig 14
G
Note:
•
Hiding the version screen can only be done by long keypressing of the 'Setup'-key and choosing a
different operation mode.
•
Most of the keyboard functions are disabled.
The pictures may differ depending on the type of PersonalScope
Fig 13
Scope: normal operation mode
Demo: Scope goes into demo mode; several animated
screens are displayed one after the other.
Y-cal.: To calibrate the centre of the signal; Use this only if the Y
position is incorrect during Auto set-up mode. (Just for HPS40)
About: Version information of the scope software is displayed
11