ASCOM Smart Series AH30 Operating Manual page 161

Message Center Messages
Messages
Message
Meter not configured or
purchased.
Waiting for Meter Frank.
Frank Previous Item or Cancel.
Meter Communication Error.
Check that meter is turned on,
connected and enabled.
Not a zone dependent rate
No valid best way comparison.
Check zone
Out of Memory
Discount exceeds current total.
Discount ignored
Not assigned
Ascom Hasler Mailing Systems, ® Inc.
Action/Comments
• [MTR LTR] or [MTR PKG] has been selected on a
scale that has not purchased the optional Meter
Interface Package.
• A postage value has already been sent to the postage
meter, an item has not been processed (franked)
through the postage meter, and another postage value
has been sent to the postage meter.
Process (Frank) an item through the postage meter.
• The AH scale did not receive an acknowledgment
signal from the postage meter. Check the following:
1- That the scale has been configured for the correct
type meter (4 bank, 5 bank decimal, etc.)
2- That the meter has power applied ... it should have a
visible display.
3- That the AH scale is connected correctly to the
meter/base combination.
• Rate is not dependent on a zone.
• Check zone and Bestway carrier setup.
• System is out of memory.
• [Dsc] has been selected and the programmed
discount value exceeds the current rate value.
For example: the postage rate is $5.50 and the discount
is programmed as a $10.00 flat rate.
• Rate not assigned.
08/99
AH30
Page F-3