ASCOM Smart Series AH30 Operating Manual page 104

PC Interfacing
AH30
The following should be done to set up the AH30:
Setup
Quick
Step
Start
1
2
3
4
5
6
7
8
9
10
11
Page 12-2
Action
Connect the PC interface cable from
the AH30 back port (labeled "PC") to
the proper port on the back of the PC.
Press the [SET UP] key on the AH30.
Use the [ ] to select [I/O Setup] and
press the [ENTER] key.
Use the [ ] to select [PC Protocol]
and press the [ENTER] key.
Select either [ASCI] or [Krmt] by
pressing the appropriate key.
Press the [EXIT/PR.MENU] key.
Use the [ ] to select [Serial Port 1]
and press the [ENTER] key.
Select [Baud Rate].
Select [9600].
Press the [EXIT/PR.MENU] key.
Select [Stop Bits].
Select [Two].
Press the [EXIT/PR.MENU] key.
Select [Parity].
Select [None].
Press the [EXIT/PR.MENU] key.
Select [Length].
Select [8].
Press the [EXIT/PR.MENU] key.
08/99
Comments
ASCII protocol does not provide any
error handling. The format is printer
compatible so that the output can be
sent to a printer.
KERMIT protocol provides error
handling while transferring data. It
requires a communication package
that supports KERMIT on the PC.
Ascom Hasler Mailing Systems, ® Inc.
AH30