Operation - Greenlee H6400C Operation Manual

Operation

Electric shock hazard:
This tool is not insulated. When
using this unit near energized elec-
trical lines:
• Use only certified non-conductive
hoses and proper personal protec-
tive equipment.
• Select and maintain the hydraulic
fluid to meet the minimum dielec-
tric standards required by your
safety department.
Failure to observe this warning
could result in severe injury or death.
Skin injection hazard:
• Do not use hands to check for
leaks.
• Do not hold hose or couplers
while the hydraulic system is
pressurized.
• Depressurize the hydraulic system
before servicing.
Oil under pressure easily punc-
tures skin, causing serious injury,
gangrene, or death. If you are
injured by escaping oil, seek medical
attention immediately.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from
flying debris or hydraulic oil.
Do not change accessories, inspect, adjust or
clean tool when it is connected to a power source.
Accidental start-up can result in serious injury.
Failure to observe this warning could result in severe
injury or death.
Greenlee / A Textron Company
H6400C Reversible Drill
1. Start the power source.
Note: Allow the power source to run for a few
minutes to warm the hydraulic fluid.
2. Set the directional control spool to the appropriate
position (forward or reverse).
Do not change the position of the directional control
spool while the tool is operating. Allow the tool to
stop before changing direction.
Failure to observe this precaution may result in
damage to the tool.
3. Grasp the handle. Place your other hand on the
top of the tool. This will allow you to apply leverage
while operating the tool.
4. To start the tool, squeeze the trigger.
5. To stop the tool, release the trigger.
6. When the tool is not in use, stop the power source
to reduce heat and wear on tool components.
9
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070