Operation - Greenlee Fairmont H6400C Operation Manual

Reversible Drills

Operation

Electric shock hazard:
This tool is not insulated. When
using this unit near energized
electrical lines:
• Use only certified non-conductive
hoses and proper personal
protective equipment.
• Select and maintain the hydraulic
fluid to meet the minimum dielectric
standards required by your safety
department.
Failure to observe this warning can
result in severe injury or death.
Skin injection hazard:
Oil under pressure easily punctures
skin causing serious injury, gangrene
or death. If you are injured by
escaping oil, seek medical attention
immediately.
• Do not use fingers or hands to
check for leaks.
• Do not hold hose or couplers while
the hydraulic system is pressurized.
• Depressurize the hydraulic system
before servicing.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection can
result in serious eye injury from
flying debris or hydraulic oil.
Do not change accessories, inspect, adjust or
clean tool when it is connected to a power source.
Accidental start-up can result in serious injury.
Failure to observe these warnings can result in
severe injury or death.
Greenlee Textron / Subsidiary of Textron Inc.
1. Start the power source.
Note: Allow the power source to run for a few
minutes to warm the hydraulic fluid.
2. Set the directional control spool to the appropriate
position (forward or reverse).
Do not change the position of the directional
control spool while the tool is operating. Allow
the tool to stop before changing direction.
Failure to observe this precaution can result in
damage to the tool.
3. Grasp the handle. Place your other hand on the
top of the tool, or on the auxiliary handle (H6400C1
and VSD6400). This will allow you to apply leverage
while operating the tool.
4. To start the tool, squeeze the trigger.
5. To stop the tool, release the trigger.
6. When the tool is not in use, stop the power source
to reduce heat and wear on tool components.
9 4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070