Table of Contents
Advertisement
Power up key functions
The table below indicates the function performed when a key is pressed and held while the
printer is powered up.
Key
FEED
PAUSE
CANCEL
Special Power Up Key Function
Enter into Feature Management Mode
Pressing and holding the FEED key until the READY LED flashes one time will
establish a communication between the Fastmark 602 PAL printer and a PC.
This communication is only on the SERIAL port of the printer and FeatureMan
must be active on the attached PC. Note: Entering into Feature Management
Mode automatically establishes the communication parameters (baud rate, parity,
etc) and can not be altered. The Printer is also in an OFF LINE state. Pressing
the PAUSE button will cancel Feature Management Mode and place the printer
ON LINE.
Disabling a PAL
Pressing and holding the FEED key until the READY LED flashes two times
will temporarily disable any loaded PAL
Cycling the printer's power will re-enable the PAL
ON LINE Key Operation
The table below indicates the functions of a key when pressed after the printer is powered
on and in the ready condition.
Key
FEED
PAUSE
CANCEL
Fastmark 600 Series User's Guide
The printer generates a configuration label. See Printing the
Configuration Label for details.
The printer performs a Calibration test. See Calibration of
Media Sensor for details.
Pressing this key bypasses any PAL
into the printer and places the printer in its normal mode.
This is done before loading a new PAL
printer. If the CANCEL key is not held down then the
current loaded application will begin running.
TM
program
No function.
Places the printer Off Line.
No function
Function
TM
program that is loaded
TM
program into the
TM
program.
TM
program.
Function
35
Advertisement
Table of Contents
