Connecting The Power Cord; Figure 6 - Power Cord Connection - AMT Datasouth Fastmark 6000 Series User Manual

Connecting the Power Cord

1. Ensure printer Power Switch is off "0".
2. Remove the yellow voltage setting label from the AC Inlet Receptacle .
3. Connect the power cord to the AC Inlet Receptacle located on the back of the printer.
4. Connect AC power plug to a suitable AC source.
Power Switch
AC Power Connector
AC Inlet Receptacle
AC Electrical Source

Figure 6 - Power Cord Connection

12 User's Guide Fastmark 6000 Series