Auto Mate AM6.2 Installation Manual page 37

■ The vehicle will start and run only for about 10 seconds.
1. Is the remote start programmed for voltage sense? Try programming the unit for low voltage reference. If this
does not work, a tach wire should be used.
2. Check diagnostics.
■ Diesel vehicle does not wait to start.
1. Is the GRAY/BLACK wire connected to the wait-to-start wire of the vehicle?
2. Check the polarity of the wait-to-start wire. (See the Finding the Wait-to-Start Bulb Wire For Diesels section
of this guide.)
3. If wiring a negative wait-to-start bulb, make sure that a diode has been placed in line on the factory wire
between the vehicle's ECM and the wait-to-start bulb. (See wiring description for the H1/6 GRAY/BLACK (-)
Diesel Wait-To-Start Bulb Input of the Primary Harness Wire Connection Guide.)
© 2007 Directed Electronics—all rights reserved
37