Turning Off The Continuous Backlighting - Bryant Legacy Owner's Manual

Advanced Programming Options

Turning off the continuous backlighting

If your thermostat is not powered by the equipment and is instead battery
powered, the display will light up for a few seconds after you press any
button. This is backlighting. It will go dark after a few seconds.
If the thermostat is powered by electricity, there is always a low level
amount of backlighting until you press any button, which increases the
lighting temporarily. Here's how to turn off the constant low level backlight
when your thermostat is powered by electricity.
1. Open the door.
2. Press and hold the home and sleep buttons under the
display simultaneously for about three seconds.
3. Press the up button at the top right of the display. You will
see U2 and On . (If you don't, continue to press the up
button, cycling through the options until you get to U2
and On .)
4. Press the mode button on the left to change it to Of .
40