Bryant Legacy Owner's Manual page 23

Programming the Thermostat
Here's how to change the factory-set time periods.
1. Open the door.
2. Press the days button at the bottom of the thermostat.
You will see all days, weekdays and weekends flashing on
the display. You will be changing the time periods
according to the days of the week. All days is used when the
household's weekday and weekend schedules are the same.
3. You must select one of these three timeframe options – all days,
weekdays or weekends – by pressing the up or down
button located to the right of the display. You may also
make your selection by pressing the days button
again. (Select all days if your weekday and weekend
schedules are the same.)
4. When you have selected one of the three options (all
days, weekdays, weekends), press the period button at
the bottom of the thermostat. You will see P and a flash-
ing 1 on the screen. This is period 1 (P1), which begins at
6:00 AM.
5. To change the hours in P1, press the start time button
at the bottom of the screen.
22