Setting The Sleep Temperature - Bryant Legacy Owner's Manual

Programming the Thermostat

Setting the sleep temperature

1. Press the sleep button located under the display in
the center. You will see a triangle icon ( ) above the
sleep button.
2. You will see the heating and cooling temperatures
that were set at the factory. To use these, just close
the door.
3. To change the factory settings, press the sleep
button. You will see the word heat flashing on the
screen.
4. Press the up or down button on the right side of the
display until you reach the desired temperature setting.
5. Press and hold the sleep button for about three seconds. The set
temperature will flash, indicating that it saved your settings.
6. To change the cooling temperature setting, press the mode button
until you see the word cool flashing on the screen.
18