Maintenance; Carburetor - Partner K950 CHAIN Operator's Manual

Carburetor

Carburetor
Your Partner product has been designed and manufactured to
specifications that reduce harmful emissions.
After your unit has been run 8-10 tanks of fuel the engine has
broken in. To ensure that your unit is at peak performance and
producing the least amount of harmful emissions after break in,
have your authorized servicing dealer, who has a revolution
counter at his disposal, to check your carburetor for optimum
operating conditions.
Functioning, Final setting
!
WARNING! Do not start the cut-off saw
without the bar, chain and cover fitted.
Otherwise the clutch can come loose and
cause personal injury.
Operation
• The carburetor governs the engine speed via the throttle.
Air/fuel are mixed in the carburetor
Jets
The carburetor is equipped with fixed jets to ensure the engine
always receives the correct fuel air mixture.
If the engine lacks power or accelerates poorly do the following:
• Inspect or, if necessary, replace the air filter.
• If this does not help, contact an authorised service workshop.
Final setting of the idling speed T
Adjust the idling speed with the screw T. If it is necessary to re-
adjust, first turn the idle speed adjusting screw T clockwise, until
the chain starts to rotate. Then turn, counter-clockwise until the
chain stops. A correctly adjusted idle speed setting occurs when
the engine runs smoothly in every position. It should also be
good margin to the rpm when the chain starts to rotate.
Recommended idling speed: 2 500 rpm.
!
Contact your servicing dealer, if the idle speed
setting cannot be adjusted so that the chain
stops. Do not use the cut-off saw until it has
been properly adjusted or repaired.

MAINTENANCE

T
17
English –