Bonding; Optional Remote Controls; Connection To A Remote Pool-Off-Spa Selector (3-Wire Connection); Install The Remote Pool-Off-Spa Selector - Jandy LRZ Electronic Installation And Operation Manual

Legacy™ Model LRZE Pool/Spa Heater Installation and Operation Manual
6.3

Bonding

CAUTION
To prevent premature failure of the appliance
resulting from stray voltages and voltage differen-
tials, the heater must be bonded to other equipment
which is part of the pool plumbing system with a
solid copper wire not smaller in diameter than 8
AWG, 6 AWG in Canada.
ATTENTION
Pour éviter le bris prématuré de l'appareil dû à
des tensions vagabondes et à des différences
de tension, le chauffe-piscine doit être scellé à
l'équipement faisant partie de la plomberie de la
piscine à l'aide d'un ¿ l de cuivre massif dont le
diamètre n'est pas inférieur à un calibre 8, et un
calibre 6 pour le Canada.
Zodiac Pool Systems, Inc. requires that the
appliance be connected to a "bonding loop" that
includes all electrical equipment in the system and on
the equipment pad. Bonding lugs must be connected
with a solid copper wire not smaller than 8 AWG (6
AWG in Canada). Failure to do so will void warranty.
Additionally, in the United States the National
Electrical Code and in Canada the Canadian Electrical
Code, require that all metallic components of a pool
structure, including reinforcing steel, metal ¿ ttings
and above ground components be bonded together
(forming a "bonding grid") with a solid copper
conductor not smaller than a 8 AWG (6 AWG in
Canada).
The NEC and the CEC also require that the
equipment and/or appliances associated with the pool
water circulating system, including, but not limited to,
pump motors and heaters be bonded together as part
of the equipotential bonding grid. Zodiac provides a
special labeled bonding lug on the right side of the
heater to accommodate this requirement.
6.4

Optional Remote Controls

WARNING
RISK OF ELECTRIC SHOCK WHICH CAN
RESULT IN SERIOUS INJURY OR DEATH. Before
attempting installation or service, ensure that all
power to the device is disconnected/turned off at the
circuit breaker.
AVERTISSEMENT
RISQUE DE CHOC ÉLECTRIQUE POUVANT
CAUSER DES BLESSURES GRAVES OU LA
MORT. Avant de tenter l'installation ou d'utiliser le
service, assurez-vous que l'alimentation allant vers
le dispositif soit débranchée/éteinte au niveau du
disjoncteur du circuit. Branchez seulement à un
circuit protégé par un disjoncteur de mise à la terre.
Electrical wiring must be in accordance with the
latest edition of the National Electric Code (NEC),
ANSI/National Fire Protection Association (NFPA) 70,
unless local code requirements indicate otherwise. In
Canada use C22.1 Canadian Electrical Code Part 1.
6.4.1 Connection to a Remote
Pool-Off-Spa Selector (3-Wire
Connection)
6.4.1.1 Install the Remote Pool-Off-Spa
Selector
1. Turn off the power to both the pool/spa control
system and the heater unit.
2. Remove the front panel door from the front of the
heater to access the raceway.
3. Run the wires from the pool/spa control system
through the opening, located on the lower right or
left hand side of the heater.
4. Connect the wiring from the pool/spa control
system to the heater remote control terminal (see
Figure 17).
Figure 17. Remote Pool-Off-Spa Connection (3-Wire
Connection)
Figure 18. AquaLink ® RS or Remote TSTAT Connection
(2-Wire Connection)
Page 23