Esp Function - LG FLEX MULTI SPLIT Installation Manual

Installation

ESP Function

E.S.P function is setting the volume of each fan speed. It is for the convenience of installation. It is
recommended that you should not use this function while using the remote controller.
PQRCUCS0C
Defrost Preheat
TEMP
FAN
MODE
SPEED
TEMP
Static pressure(mmAq)
Model name
8.5 CMM(300cfm)
AMNW09GB1A0
7.5 CMM(265cfm)
[LMDN095HV]
6.5 CMM(230cfm)
9.5 CMM(335cfm)
AMNW12GB1A0
8.5 CMM(300cfm)
[LMDN125HV]
7.5 CMM(265cfm)
15 CMM(530cfm)
AMNW18GB2A0
13.5 CMM(477cfm)
[LMDN185HV]
11.5 CMM(406cfm)
28 Multi Air Conditioner
Out door
Room Temp
Total on
Central Run
Step(H/M/L)
75
69
62
82
75
69
90
82
75
1 Press the mode button and the temperature in-
creasing button(s) same time for three seconds.
2 Set the volume of each fan speed(Low, Medium, Hi)
by using the temperature control button. Press the
fan speed button to select the fan speed.
The value of E.S.P can be adjusted from 1 to 255.
3 If you press the On/Off button while setting the ESP
function, it will be canceled. (The picture on the left
side is the example of setting the Hi wind to ESP 10.)
4 Press the mode button and the temperature in-
creasing button (s) same time for three seconds.
Then the ESP setting will be activated after the
temperature display flashes three times.
EX)
Lo
200
Setting the Low wind to 210
h The E.S.P value is set at the proper value at the fac-
tory. So it is highly recommended that you should not
change the E.S.P value at your discretion.
0 1
84
77
71
90
84
77
97
90
84
Med
100
Setting the Medium wind to 175
2 3
Setting value
94 104
88 99
83 95
99 109
94 104
88 99
105 114
99 109
93 103
4
114
110
106
118
114
110
122
119
114