Esp Function - LG LMCN125HV Instructions Manual

ESP Function

E.S.P function is setting the volume of each fan speed. It is for the convenience of installation. It is
recommended that you should not use this function while using the remote controller.
PQRCUCS0C
Defrost Preheat Out door
TEMP
FAN
MODE
SPEED
TEMP
Static pressure(mmAq)
Step(H/M/L)
Model name
8.5 CMM(300cfm)
AMNW09GB1A0
7.5 CMM(265cfm)
[LMDN095HV]
6.5 CMM(230cfm)
9.5 CMM(336cfm)
AMNW12GB1A0
8.5 CMM(300cfm)
[LMDN125HV]
7.5 CMM(265cfm)
15 CMM(530cfm)
AMNW18GB2A0
13.5 CMM(477cfm)
[LMDN185HV]
11.5 CMM(406cfm)
1
2
Room Temp
Total on
Central Run
3
4
❈ The E.S.P value is set at the proper value at the
0
75
69
62
82
75
69
90
82
75
Press the mode button and the temperature
increasing button(L) same time for three
seconds.
Set the volume of each fan speed(Low, Medium, Hi)
by using the temperature control button. Press the
fan speed button to select the fan speed.
The value of E.S.P can be adjusted from 1 to 255.
If you press the On/Off button while setting the ESP
function, it will be canceled. (The picture on the left
side is the example of setting the Hi wind to ESP
10.)
Press the mode button and the temperature
increasing button (L) same time for three
seconds. Then the ESP setting will be activated
after the temperature display flashes three times.
EX)
Lo
200
Setting the Low wind to 210
factory. So it is highly recommended that you should
not change the E.S.P value at your discretion.
1 2
Setting value
84 94
77 88
71 83
90 99
84 94
77 88
97 105
90 99
84 93
Installation
Med
100
Setting the Medium wind to 175
3
104 114
99 110
95 106
109 118
104 114
99 110
114 122
109 119
103 114
Installation Manual 25
4