Heating Up Before Every Use; Heating Up After An Extended Downtime - Silvercrest SEM 1100 A2 Operating Instructions Manual

Heating up before every use

Before you can prepare an espresso or cappuccino, the appliance must be heated
up.
1) Switch the appliance on with the
the position „
2) The red heating-up control lamp
3) Wait until the green heating-up control lamp
You can now make an espresso / cappuccino.

Heating up after an extended downtime

If you have not used it for some time, preheat the appliance as follows:
1) Fill the water tank
2) Place either the large
w.
3) Insert the sieve carrier
"INSERT" and then turning it anticlockwise to the marking "LOCK".
4) Place a cup under the sieve carrier
5) Close the steam regulation knob
" - ").
6) Switch the appliance on with the on/off switch
7) The red heating-up control lamp
8) Turn the rotary switch
into the appliance. As soon as water fl ows from the sieve carrier opening, turn
the rotary switch 5 back to the position "
9) As soon as the green heating-up control lamp
5 to the position "
that you need to empty the cup in between. For this, briefl y stop the process.
10) After approx. 1 minute turn the rotary switch back to the position "
11) Wait until the green heating-up control lamp
is concluded. You can now prepare espresso.
SEM 1100 A2
on/off switch 3. The rotary switch 5 is at
".
i glows.
1 with water.
q or the small espresso sieve 0 in the sieve carrier
w into the appliance by placing it at the marking
w.
2 (turn it as far as it will go in the direction
i glows.
5 to the position "
". Allow the water to fl ow for about 1 minute. It may be
4 glows.
3.
". The pump begins to pump water
".
4 glows, turn the rotary switch
4 glows again. The warming-up
GB
IE
".
9