Heating Up Before Every Use - Silvercrest SEMS 1100 B2 Operating Instructions Manual

3) Place the sieve holder i in the appliance by inserting the "
mark, which is located next to the hot water shower 0, into the appliance and
then turning it clockwise until the handle of the sieve holder i is facing the
front ("
4) Place a cup under the sieve holder i.
5) Turn the steam control 2 to "0".
6) Switch the appliance on with the on/off switch
7) The red control lamp „Power"
the temperature indicator 1 will begin to rise.
8) As soon as the green heating-up control lamp
"Espresso" button
NOTE
► You may need to empty the cup in between. Interrupt the process by
pressing the "Espresso" button
"Espresso" button
9) After about 1 minute, stop the pump by pressing the "Espresso" button
again.
10) Wait until the green heating-up control lamp
warming-up is concluded. You can now prepare espresso.

Heating up before every use

Before you can prepare an espresso or cappuccino, the appliance must be
heated up.
1) Switch the appliance on using the on/off switch
„Power"
z buttons should be pressed in. Ensure that the steam control 2 is turned
towards "0" as far as possible.
2) Place the sieve holder i in the appliance by inserting the "
mark, which is located next to the hot water shower 0, into the appliance and
then turning it clockwise until the handle of the sieve holder i is facing the
front ("
3) Press the "Espresso" button
water tank 5. As soon as water starts exiting the openings in the sieve holder,
press the "Espresso" button
4) Wait until the green heating-up control lamp
5) Press the "Espresso" button
for 20 seconds before stopping the pump again.
The preheating process is completed. You can now make an espresso/cappuccino.
│ GB │ MT
■ 36
LOCK" mark).
t. Allow the water to flow for about 1 minute.
t again so that water flows through the appliance.
w lights up. Neither the "Espresso"
LOCK" mark).
t so that the appliance draws water from the
t again to stop the pump.
t again and allow hot water to flow through
r.
w lights up. After a short time, the pointer in
e lights up, press the
t. Empty the cup and press the
e lights up again. The
r. The red control lamp
t nor the "Steam"
e lights up.
INSERT"
t
INSERT"
SEMS 1100 B2