Heating Up Before Every Use - Silvercrest SEMS 1100 A1 Operating Instructions Manual

3) Place the sieve holder
mark, which is located next to the hot water shower
then turning it clockwise until the handle of the sieve holder
front ("
4) Place a cup under the sieve holder
5) Turn the steam control
6) Switch the appliance on with the on/off switch
7) The red control lamp „Power"
the temperature indicator
8) As soon as the green heating-up control lamp
"Espresso" button
NOTE
► You may need to empty the cup in between. Interrupt the process by
pressing the "Espresso" button
"Espresso" button
9) After about 1 minute, stop the pump by pressing the "Espresso" button
again.
10) Wait until the green heating-up control lamp
warming-up is concluded. You can now prepare espresso.

Heating up before every use

Before you can prepare an espresso or cappuccino, the appliance must be
heated up.
1) Switch the appliance on using the on/off switch
„Power"
buttons should be pressed in. Ensure that the steam control
towards "0" as far as possible.
2) Place the sieve holder
mark, which is located next to the hot water shower
then turning it clockwise until the handle of the sieve holder
front ("
3) Press the "Espresso" button
water tank
press the "Espresso" button
4) Wait until the green heating-up control lamp
5) Press the "Espresso" button
for 20 seconds before stopping the pump again.
The preheating process is completed. You can now make an espresso/cappuccino.
│ GB │ IE
■ 36
in the appliance by inserting the "
LOCK" mark).
to "0".
will begin to rise.
. Allow the water to flow for about 1 minute.
again so that water flows through the appliance.
lights up. Neither the "Espresso"
in the appliance by inserting the "
LOCK" mark).
. As soon as water starts exiting the openings in the sieve holder,
, into the appliance and
.
.
lights up. After a short time, the pointer in
lights up, press the
. Empty the cup and press the
lights up again. The
. The red control lamp
nor the "Steam"
, into the appliance and
so that the appliance draws water from the
again to stop the pump.
lights up.
again and allow hot water to flow through
INSERT"
is facing the
is turned
INSERT"
is facing the
SEMS 1100 A1