Cleaning And Care; Cleaning The Milk Frother; Cleaning The Hot Water Shower - Silvercrest SEM 1100 A2 Operating Instructions Manual

Cleaning and Care

WARNING - RISK OF INJURY!
■ Always remove the plug from the mains power socket before you clean the
appliance. Risk of electric shock!
■ Always allow the appliance to cool down before you start to clean it. Risk of
Burns!
■ NEVER submerse the appliance in water or other liquids. Risk of electric
shock!

Cleaning the milk frother

ATTENTION - PROPERTY DAMAGE
■ NEVER use abrasive, corrosive or chemical agents to clean the appliance.
These could damage the upper surfaces of the appliance.
1) Place an empty container under the milk frother
2) Immediately after use turn the steam control knob
for a few seconds, allow the steam to escape.
3) Turn the steam control knob
switch the appliance off and remove the plug from the mains power socket.
4) Allow the nozzle to cool down.
5) Remove the nozzle and clean it thoroughly in warm water.
6) Check to see if the small hole in the nozzle is clogged and, if so, clear it with
a needle.
7) Clean the steam delivery tube of the milk frother
8) Replace the nozzle back onto the steam supply pipe.

Cleaning the hot water shower

Clean the hot water shower t after each use:
1) After you have prepared the espresso/cappuccino and removed the sieve
holder w, wipe the entire surface of the hot water shower t with a moist
cloth so that all powder residues are removed.
2) Then place an empty cup under the hot water shower
rotary knob 5 to the position „
t and it fl ushes the last remaining powder residues out. With this, the water
can spray a little.
3) After about 20 seconds place the function rotary knob
„
SEM 1100 A2
" and switch the appliance off with the On/Off switch 3.
z.
2 to the position "+ " and,
2 off (as far as it will go in the direction "-"),
z with a damp cloth.
". Water fl ows from the hot water shower
t and turn the function
5 back to the position
GB
IE
15