Server Switches Off Itself; Screen Remains Blank - Fujitsu Primergy TX100 S2 Operating Manual

Troubleshooting and tips
Ê Press the push button mains switch (see figure
"Rear of server" on page
Ê Switch on your server with the power On/Off button at the front bezel.
7.2

Server switches off itself

Server Management has detected an error
Ê Check the error list in the System Event Log in ServerView Operations
Manager, and attempt to eliminate the error.
7.3

Screen remains blank

Monitor is switched off
Ê Switch on your monitor.
Screen has gone blank
Ê Press any key on the keyboard.
or
Ê Deactivate the screen saver. Enter the appropriate password.
Brightness control is set to dark
Ê Set the brightness control on the monitor to light. For detailed information,
refer to the operating manual supplied with your monitor.
Power cable or monitor cable not connected
Ê Switch off the monitor and the server.
Ê Check whether the power cable is properly connected to the monitor and to
the grounded power outlet.
Ê Check whether the monitor cable is properly connected to the server and
monitor (if it is plugged in with a connector). If a separate graphics card is
installed in the server, then the monitor cable must be connected to the
graphics card.
58
47.
Operating Manual
5 on page 47 in chapter
T X100 S2