5.3.3
Configuring the server and installing the operating
system without the ServerView Installation
Manager
Configuring the onboard SATA controller
Configure the controller as described in section
controller" on page
Installing the operating system
Ê Insert the CD/DVD for the operating system you want to install.
Ê Reboot the server.
Ê Follow the instructions on screen and in the manual for the operating
system.
5.4
Cleaning the server
V
CAUTION!
Switch the server off and disconnect the power plugs from the properly
grounded power outlets.
Do not clean any interior parts yourself; leave this job to a service
technician.
Do not use any cleaning agents that contain abrasives or may corrode
plastic.
Ensure that no li q uid enters the system. Ensure that theventilation areas
of the server and the monitor are clear.
Do not use any cleaning sprays (including flammable types). It may
cause a device failure or a fire.
Clean the keyboard and the mouse with a disinfecting cloth.
Wipe the server and monitor casing with a dry cloth. If particularly dirty, use a
cloth that has been moistened in a mild domestic detergent and then carefully
wrung out.
TX100 S2
51.
Operating Manual
Installation and operation
"Configuring the onboard SATA
53