Setting Up The Server - Fujitsu Primergy TX100 S2 Operating Manual

4.2

Setting up the server

V
CAUTION!
Follow the safety instructions in
Ê Set up the server.
V
CAUTION!
– The device must be protected from direct sunlight.
– Ensure that the minimum clearances (see
on page
– Access to the rear of the server must be assured so that other
devices (e.g. memory subsystems) can be connected.
– The mains plug must be accessible easily and safely.
– A clearance of at least 200 mm must be maintained in front of and
behind the system to ensure proper ventilation.
Ê Wire the server. Read the information in
server" on page 40
on page 43.
Ê Connect the system to the mains (see
mains" on page
TX100 S2
17) are observed.
and section "Notes on connecting/disconnecting cables"
42).
Operating Manual
Installing the hardware
chapter "Important notes" on page
"Ventilation clearance"
section "Connecting devices to the
section "Connecting the server to the
21.
39