Supermicro SUPERSERVER 6016T-URF4+ User Manual page 72

S S
UPER ERVER 6016T-URF4+/6016T-NTRF4+ User's Manual
LAN1/LAN2 Enable/Disable
Change the setting of jumper JPL1
and/or JPL2 to enable or disable the
LAN1 and LAN2 onboard Ethernet
(RJ45) ports, respectively. See the
table on the right for jumper settings.
The default setting is enabled.
Watch Dog Enable/Disable
JWD1 controls the Watch Dog function.
Watch Dog is a system monitor that
can reboot the system when a software
application "hangs". Pins 1-2 will cause
WD to reset the system if an applica-
tion hangs. Pins 2-3 will generate a
non-maskable interrupt signal for the
application that has hung. See the table
on the right for jumper settings. Watch
Dog must also be enabled in BIOS.
Note: When enabled, the user needs to
write their own application software to
disable the Watch Dog Timer.
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
SMB to PCI Express Slots
2
Jumpers JI C1 and JI
connect the System Management Bus
2
(I C) to the PCI Express slots. Both
jumpers must have the same setting to
function correctly. The default setting is
disabled. See the table on the right for
jumper settings.
2
C2 allow you to
5-24
LAN Enable/Disable
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
VGA Enable/Disable
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
SMB to PCI-Exp
Jumper Settings
Jumper Setting Defi nition
Closed Enabled
Open Disabled