Table of Contents
Advertisement
FLAME CHARACTERISTICS
Check for proper burner flame characteristics. Each
burner is adjusted prior to shipment; however,
variations in the local gas supply may take minor
adjustments necessary.
Burner flames should be blue and stable with no
yellow tips, excessive noise, or lifting. If any of these
conditions exist call our customer service line. If the
flame is yellow, it indicates insufficient air. If the
flame is noisy and tends to lift away from the burner, it
indicates too much air.
TO MATCH LIGHT THE GRILL
If the burner will not light after several attempts then
the burner can be match lit.
Lighting rod-Here is your instruction:
Match light extension rod
Use this device to match light your burners
Simply place a lighted match between the coils on the end of
the extension rod and hold next to the burner to ignite. (see
reference Pg)
WARNING: IMPORTANT!
USING THE SIDE BURNER:
Inspect the gas supply hose prior to turning the gas
"ON". If there is evidence of cuts, wear or abrasion, it
must be replaced prior to use. Do not use the side
burner if the odor of gas is present.
GRILL LIGHTING INSTRUCTIONS
USING SIDE BURNER
25
If you've just attempted to light the burner with the
igniter, allow 5 minutes for any accumulated gas to
dissipate. Keep your face and hands as far away from
the grill as possible. Insert a lit match attached to tight
lighting rod or lighter through the cooking
grids to the burner.(see next page) Press the control
knob and rotate left to the HI setting, continue to press
the knob until the burner ignites. Burner should light
immediately. If the burner does not light in 4 seconds
turn the knob off, wait 5 minutes and try again.
Keep a spray bottle of soapy water near the gas supply
valve and check the connections before each use.
Do not attempt to light the grill if odor of gas is
present. Call for service 1-800-913-8999
WARNING: Always keep your face and body as far
away from the burner as possible when lighting.
LIGHTING INSTRUCTIONS
To light the side burner, remove any cooking utensils
from the burner grate. Push and turn the control knob
counterclockwise to the "HI" position. If the burner
does not light, turn the
Advertisement
Table of Contents
