Table of Contents
Advertisement
Keep the rotisserie motor electric cord away
from the heated surfaces of the grill. When
not in use remove and store the motor in a
dry location.
WARNING: IMPORTANT!
BEFORE LIGHTING...
Inspect the gas supply hose prior to turning the gas
"ON". If there is evidence of cuts, wear, or abrasion, it
must be replaced prior to use. Do not use the grill if
the odor of gas is present. Only the pressure regulator
and hose assembly supplied with the unit should be
used. Never substitute regulators for those supplied
with the grill. If a replacement is necessary, contact
the factory for proper replacement.
Screw the regulator (type QCC1) onto the tank. Leak
check the hose and regulator connections with a soap
and water solution before operating the grill.
OPERATING INSTRUCTIONS
GRILL LIGHTING INSTRUCTIONS
WARNING:
ELECTRICAL GROUNDING INSTRUCTIONS: This
appliance (rotisserie motor) is equipped with a plug and
should be plugged directly into a properly grounded
receptacle. DO NOT cut or remove the grounding prong
from this plug.
TO LIGHT THE GRILL BURNER:
Make sure all knobs are "OFF" then turn on the gas
supply from the LP tank. Always keep your face and
body as far from the grill as possible when lighting.
Your stainless steel grill has an exclusive patented built-
in ignition. The igniter is built in to the valve. To ignite
each burner simply push and turn the control knobs to
the HI setting, you will hear the valve click as it sends a
spark to the pilot flame. If the burner does not light wait
5 minutes for any excess gas to dissipate and then retry.
24
Advertisement
Table of Contents
