How To Set To Freewheel Mode - Drive Medical Sunfire General Owner's Manual

To change the seat height
Remove seat (See "To remove the Seat")
Remove the shroud.
Disengage and remove the seat height adjustment bolt from the seat post.
Remove the height adjustment bolt from each of the three posts.
Raise or lower each post to the desired position.
Reinstall the seat height adjustment bolt through the seat post.
Reinstall the shroud.
Reinstall the seat.
HOW TO ADJUST THE FOOTREST
To adjust the footrest angle
You can adjust the angle of the footrest with a hex wrench (M6).
Turn the setscrew clockwise to raise or lower the front of the footrest.
To adjust the footrest height
Remove the quick release pin.
Adjust footboard to one(1) of three (3) mounting positions.
Install the quick release pin. Make sure the detent ball is engaged with the outer edge of the tube.

HOW TO SET TO FREEWHEEL MODE

For your convenience, the Sunfire General is equipped with a freewheel level. This level allows you
to disengage the drive motors and maneuver the chair manually.
To engage the drive and take power chair out of freewheel
Pull the freewheel lever to "DRIVE" position(left and right).
Activation of the joystick automatically releases the brake so the powered wheel chair can be
drive.
To disengage the drive and place power chair in freewheel
Push the freewheel lever to "NEUTRAL" position left and right)
5 . O P E R AT I O N
17