Fitting The Rear Wheel - NuVinci Harmony Owner's Manual

BASic MAiNTENANcE AND cArE

Fitting the rear Wheel

Place the rear wheel into the
4
frame, making sure not to obstruct
or pinch the Harmony wire
harness and Main Connector.
„ Orient the chain around the
Harmony Hub Interface and
onto the sprocket.
„ In some cases, it is easiest to
remove the chain from the front
chain ring to ease rear wheel
installation.
Note location of wheel speed
sensor (4) at rear wheel – the
chain should not catch on this
sensor when fitting the wheel.
5
Slide one no-turn washer (3)
each onto each axle end. The ser-
rations of the no-turn washer must
bear against the dropout of the
frame. The rectangular boss must
engage the dropout of the frame.
6
Mount the axle nuts (2).
Tightening torque 30 – 40 Nm
(266-350 in-lbs).
„ For rim and roller brake
applications, connect the
rear brake according to the
manufacturer's instructions.
Install the Harmony Main
7
Connector by lining up the
arrows (5) and carefully
pressing together.
1 4
4
5-6
3
2
7
4
3 2
5
EN
5