Feed Motor - Toshiba SD-2050 Service Manual

Rack gear assembly (4)
Gear A (2)
Positioning holes
A
Gear B assembly (1)
Fig. 2-1-19
Note:
• Mount the gear B assembly (1) and the gear A (2) with
their gear teeth placed more than one tooth at least
inside the shaded portion.
Innermost position
of pickup head
Rack gear assembly (4)
Gear A (2)
Fig. 2-1-20
B
Pickup Head (5)
Pickup mechanism
assembly
Within the position shown
by the shaded porition.
Gear B assembly (1)

1-3-6. Feed Motor

<Removal>
1. Remove the gear B assembly (1) and the gear A (2).
(Refer to item 1-3-5.)
2. Remove two screws (1) and remove the feed motor (2)
(with the feed motor PC board (3) attached).
(Refer to Fig. 2-1-21.)
3. Desolder the terminals of the feed motor (2) and
remove the feed motor PC board (3).
<Mounting>
1. Tighten the feed motor (2) on the pickup mechanism
assembly with two screws (1).
2. Insert the feed motor PC board (3) with the position-
ing pin on the chassis matched and solder the termi-
nals.
3. Perform the reverse order of the removal.
Note:
• After mounting, put the lead wires through the notch
of the pickup mechanism assembly.
Screws (1)
Pickup mechanism
assembly
Feed motor (2)
Feed motor
PC board (3)
Fig. 2-1-21
Notch
Lead wires
Desolder