Toshiba SD-2050 Service Manual page 69

1-3-3. Loading Motor
<Removal>
1. Remove the loading belt. (Refer to item 1-3-2.)
2. Remove two screws (1).
3. Remove four screws (2) and remove the loading motor
(3) (with the loading motor PC board (4) attached).
4. Desolder the terminal part of the loading motor (3)
and remove the loading motor PC board (4).
5. Replace the loading motor (3).
Screws (1)
Loading motor (3)
Loading motor
PC board (4)
SW1
SW3
Screws (2)
Fig. 2-1-13
<Mounting>
1. Eject the second tray 2 . (Set the POM mark of the
cam to the position as shown in Fig. 2-1-14.)
Second tray 2
2. Solder the terminals of the loading motor (3) on the
3. Since the switch of SW3 comes over the external
4. With the loading motor PC board (4) held, tighten two
5. Tighten two screws (1).
6. Mount the loading belt.
SW2
7. Close the second tray 2 .
Eject
Fig. 2-1-14
loading motor PC board (4) .
peripheral portion of the cam, push the switch by
inserting a spacer to the clearance between the chassis
and the loading motor PC board (4). (Refer to Fig. A.)
screws (2)-1 on the loading motor (3) side and then fix
two screws (2)-2.
Fig. A
Screws (2)-2
Loading motor
PC board (4)
Spacer
Push
SW3
Cam
Chassis
SW3
Cam
Chassis
Second tray 2
Fig. 2-1-15
Cam
POM mark
position
Chassis
Screws (2)-1
Loading motor
PC board (4)
Loading
motor (3)
SW3
Cam
Screws (1)