Toshiba SD-2050 Service Manual page 70

1-3-4. Pickup Mechanism Assembly
<Removal>
1. Turn over the mechanism chassis assembly (1).
2. Remove the flexible cables (2) at two locations.
3. Remove four screws (3) and remove the pickup
mechanism assembly (4).
<Mounting>
1. Replace the pickup mechanism assembly (4) with a
new one.
Remove dampers from the old pickup mechanism
assembly used and mount the dampers on the new
pickup mechanism assembly.
2. When mounting, perform the reverse steps of the
removal described above.
Screws (3)
Pickup mechanism
assembly (4)
Dampers
(Gray)
Fig. 2-1-16
Note:
• The dampers' color differs when used for the front
side and the rear.
• When mounting the pickup mechanism assembly (4)
with the screws (3), push the pickup mechanism
assembly (4) downward without being caught and
tighten the screws (3) after placing the washer with the
damper bent.
Screw (3)
Pickup mechanism
assembly (4)
Damper
Fig. 2-1-17
Dampers
(Green)
Flexible
cables (2)
Mechanism chassis
assembly (1)
1-3-5. Gear B Assembly, Gear A and Rack Gear
Assembly
<Removal>
1. Remove one screw (1) and remove the gear B assembly
(2).
2. Remove the gear A (3).
3. Remove one screw (4) and remove the rack gear
assembly (5).
Screw (1)
Gear B
assembly (2)
Gear A (3)
Pickup mechanism
assembly
Fig. 2-1-18
<Mounting>
1. When mounting, perform the reverse order of the
removal.
2. Mount the gear B assembly (1) by pushing the pickup
head (5) to the disc motor side (arrow A direction) and
shifting the upper gear of the rack gear assembly (4) in
the arrow B direction. (Refer to Fig. 2-1-19.)
3. Fit the positioning holes on the upper gear and lower
gear of the gear B assembly (1) and mount on the
pickup mechanism assembly with the phase matched.
At this time, note that the phase of the gear B assem-
bly (1) and the gear A (2) shows the status in the Fig.
2-1-20.
Screw (4)
Rack gear
assembly (5)