Timer Operation - Toshiba MCY-MAP0401HT Owner's Manual

Changing the set temperature
1
Push the "TEMP. " buttons.
Push to increase the temperature, and
decrease the temperature. (The set temperature
cannot be changed in the fan mode.)
NOTE
When cooling
Running starts in approximately 1 minute.
When heating
• The air conditioner may continue running in the fan
mode for about 30 seconds after stopping heating.
• The heated air comes out after a 3 to 5 minutes of
pre-heating with the indoor fan kept turned off. (The
pre-heat indicator is displayed on the remote
controller.)
• The fan speed becomes extremely low when the
room temperature has reached the set temperature.
However, for concealed duct high static types, the
fan speed does not change after the temperature
has reached to the set temperature.
17-EN
Power save operation
to
Displayed
during Power
save operation.
TEMP. ON / OFF
TIMER SET FAN MODE
Save button
TIME SAVE VENT
FILTER
RESET TEST SET CL SWING/FIX UNIT LOUVER
1
Push the button during operation.
• Power save operation is activated.
• is appeared.
2
Push button to deactivate Power save
operation.
• is disappeared.
NOTE
• Capability of the air conditioner is saved during the
Power save operation. The room may not become
cool or warm enough.
• Power save operation will not be deactivated by stop
operation, change operation mode or turn off the
power switch.
– 9 –
5

Timer operation

Select a timer type from the following three: (Max. 168 hours)
OFF timer : Stops running after the specified period.
Repeat-OFF timer : Stops running after the specified period every time you use the air conditioner.
On timer : Starts running after the specified period.
Setting the timer
1
3
1
Push the button.
Each time you push the button, the timer mode
and indication change in the following order:
Off
Off
(Off timer) (Repeat Off timer)
No indication (Timer
function is deactivated)
• and the time indicator blink.
2
Push the buttons to set the period of
time until the timer actions.
• The time setting increases in 0.5-hour (30-
minute) increments each time you push
The setting increases in 1-hour increments if it is
over 1d (24 hours). The maximum is 7d (168
hours).
On the remote controller, settings between 0.5h
and 23.5h (*1) are displayed as is.
If it is over 24 hours (*2), the days and hours
appear.
• The time setting decreases in 0.5-hour (30-
minute) decrements (0.5 hours to 23.5 hours) or
1-hour decrements (24 hours to 168 hours)
each time you push .
Example of remote controller display
• 23.5 hours (* 1 )
2
2
• 34 hours (* )
indicates 1 day
(24 hours).
indicates 10 hours.
(Total: 34 hours)
On
3
Push the button.
(On timer)
• disappears, the time indication is
displayed, and or
display flashes.
(When using the ON timer, all indications other
than the time and turn off.)
Cancelling the timer
1
.
Push the button.
The timer indicator disappears.
NOTE
• When using Repeat OFF timer, pushing the
button after stopping by the timer starts running
again and the timer will stop the running again after
the specified period.
• When using OFF timer, the timer indication
temporarily disappears for about 5 seconds by
SWING/FIX
pushing the button. This occurs due to the
processing in the remote controller, and is not a
malfunction.
Days Hours
18-EN