Part Names And Functions Of The Remote Controller - Toshiba MCY-MAP0401HT Owner's Manual

◆ Floor Standing Cabinet Type
Air filter
Filters out dust.
(Inside the return air grille)
◆ Floor Standing Concealed Type
Air discharge
Earth screw
Equipped on the electrical
control box.
Air intake
Air in the room is taken in
through here.
◆ Floor Standing Type
Discharge louver
Controls discharge air directions.
Earth screw
Equipped on the electrical
control box.
Air filter
Filters out dust
Air intake
Air in the room is taken in
through here.
11-EN
Discharge louver
Controls discharge air directions.
Earth screw
Return air grille
Air in the room is taken in through
here.
Drain funnel (with strainer)
Accessory to be attached at the site
Air filter
Filters out dust.
(Inside the return air grille)
Front panel (lower)
Metal fittings
Vertical louver
Automatically directs the airflow
horizontally at regular intervals.
Drain pan
Water collected here is drained out
through the drain pipe.
Metal fittings (left / right)
3
Part names and functions of the remote
controller
This remote controller can control up to 8 indoor units.
Display section
All indicators are displayed in the display example below.
Actually, only the selected options will be displayed.
• blinks on the display of the remote controller the first time the power
switch is turned on.
• The initial settings progress while
controller after has disappeared.
NOTE
The LCD may temporarily be blurred due to static electricity.
2
3
4
5
6
21
15
16
1
SETTING indicator
Displayed when setting the timer or other
functions.
2
Operation mode indicator
Indicates the operation mode selected.
3
Error indicator
Displayed when the protective device activates or
an error occurs.
4
Time display
Indicates time concerning the timer.
(Indicates an error code when an error occurs)
5
Timer mode indicator
Displays the timer mode.
6
Filter indicator
Reminder to clean the air filter.
– 6 –
TEMP.
is blinking. Start to use the remote
TIMER SET FAN
TIME SAVE
FILTER
RESET TEST SET CL SWING/FIX
17
18
1 7 8 9
10
11
12
14
7
TEST run indicator
Displayed during test run.
8
Louver position display
Indicates the louver position.
* Only for 4-way cassette, 1-way cassette, 2-way
cassette, ceiling types
Display
section
ON / OFF
Operation
MODE
section
VENT
UNIT LOUVER
19
20
13
EN
12-EN