Automatic Operation (Auto Changeover); Timer Operation - Toshiba MMK-UP0271HP-E Owner's Manual

Automatic operation
(auto changeover)
This function is available only for use in
combination with a heat recovery model outdoor
unit. If this function is used with another model of
outdoor unit, "A" (Auto) appears on the remote
controller but the automatic operation is disabled.
Press this button to start the air conditioner.
Select A.
Set the desired temperature.
Select one of
MED , MED
• The OPERATION lamp on the display panel
of the indoor unit lights.
The operating mode is selected in accordance
with the room temperature and operation starts
after approximately 3 minutes.
• If the "A" mode is uncomfortable, you can select
the desired conditions manually.
Press this button again to stop the air conditioner.
If you select AUTOMATIC OPERATION in a model
with no auto-changeover (cooling/heating) control
setting or if you select HEAT in a Cool Only model,
lamp lights up and
alternately with an alarm sound (pi, pi) from the
air conditioner due to disagreement in operation
mode. Change the operation mode with the MODE
button on the wireless remote controller. This
disagreement indication cannot be deleted by the
wired remote controller.
9-EN
1
3
2
4
SWING FAN
LOW , LOW + ,
+ , HIGH
CAUTION
and lamps blink

Timer operation

Use the wired remote controller for timer setting if it
is also in use.
COMFORT
SLEEP
Press the ON or OFF TIMER buttons as required.
• The previous timer setting is displayed and ashes
along with ON/OFF timer display.
Set the timer to the desired time.
Each press of the TIMER button changes the
.
time in ten minute steps.
Pressing the TIMER button continually changes
the time in one hour step.
Press the SET
The timer time is indicated and the timer starts.
Press the CLR
• When you select the timer operation, the remote
controller automatically transmits the timer signal
to the indoor unit at the speci ed time. Therefore,
keep the remote controller in a location where it
can transmit the signal to the indoor unit properly.
Otherwise, the time lag of up to 15 minutes will
occur.
• If you do not press the SET
30 seconds after setting the time, the setting will
be cancelled.
- 9 -
SWING FAN
FIX QUIET
1
Hi POWER
3
2
button to set the timer.
button to cancel the timer setting.
CAUTION
button within