Installation Instructions; Pre-Installation Procedures - Aquatic Infinity Owner's Manual & Installation Manual

Whirlpool bath

Hide thumbs Also See for Infinity:

Owner's manual & installation manual (36 pages)

Table Of Contents

Table of Contents

PRE-INSTALLATION PROCEDURES

PLEASE NOTE: THE MANUFACTURER ACCEPTS A + 3/8" VARIANCE. THERE ARE VARIATIONS ON EACH TUB

AND SPECIFICATIONS ARE SUBJECT TO CHANGE AS WE IMPROVE UPON OUR PRODUCT AS REQUIRED.

THE DIMENSIONS NEEDED FOR SITE PREPARATION AND STRUCTURE BUILDINGS SHOULD BE MEASURED FROM

THE TUB; AQUATIC ASSUMES NO RESPONSIBILITY FOR PREPARATORY WORK.

Note: A good knowledge of construction techniques, plumbing and electrical installation according to codes are re-

quired for proper installation. We recommend that a qualified licensed contractor perform the installation of all Aquatic

products. Our warranty does not cover improper installation related problems.

1. Immediately upon receiving your Aquatic whirlpool bath inspect it thoroughly for freight damage. If necessary,

contact your dealer/distributor immediately (your dealer/distributor must contact Aquatic, Inc. within 24 hours of

receiving unit to file a claim.) Should inspection indicate any damage, do not install the bath.

2. All baths are filled with water and operated in our manufacturing facility prior to shipment. Inspectors ensure

watertight operation, however, rough handling may cause leaks which may be detected prior to installation.

Damage or defect to the finish claimed after the bath is installed is not covered under the warranty.

To Inspect:

1. Place the tub in an area where it may be drained after testing.

2. Fill the tub with hot water (approximately 100° F) to the overflow and allow to stand for a few minutes.

Carefully inspect all fittings and connections for leaks.

3. Plug in pump and blower cords and run pump for 10 minutes.

4. With the pump running, turn on the blower. Check all functions.

5. Inspect the tub completely. Any defect must be reported to Aquatic prior to installation in order to have it covered by

warranty. Should inspection indicate any damage, do not install the bath.

6. Check to ensure that your installation will conform to all applicable codes and secure necessary permits.

All electrical and plumbing connections should be made by qualified electricians and plumbers.

Damage or leaks claimed after the bath is installed are not covered under the warranty.

WARNING: failure to follow these instructions during installation will result in termination of the warranty: Do not lift the

tub by any portion of the plumbing or pump. Do not stand in the tub during construction.

DO NOT MAKE ANY ALTERATIONS, ADDITIONS, OR DELETIONS TO THE WHIRLPOOL SYSTEM PUMP OR BATH.

WARNING: Whirlpool pump and piping are factory assembled. Relocation of pump or other modifications could

adversely affect the performance and safe operation of this whirlpool. Aquatic shall not be liable under its warranty or

otherwise for personal injury or damage caused by any such unauthorized modification.