Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
PRE-INSTALLATION PROCEDURES
PLEASE NOTE: THE MANUFACTURER ACCEPTS A + 3/8" VARIANCE. THERE ARE VARIATIONS ON EACH TUB AND
SPECIFICATIONS ARE SUBJECT TO CHANGE AS WE IMPROVE UPON OUR PRODUCT AS REQUIRED.
THE DIMENSIONS NEEDED FOR SITE PREPARATION AND STRUCTURE BUILDINGS SHOULD BE MEASURED FROM
THE TUB; AQUATIC, ASSUMES NO RESPONSIBILITY FOR PREPARATORY WORK.
Note: A good knowledge of construction techniques, plumbing and electrical installation according to codes are
required for proper installation. We recommend that a qualified licensed contractor perform the installation of all
Aquatic products. Our warranty does not cover improper installation related problems.
1. Immediately upon receiving your Aquatic air-whirlpool bath, inspect it thoroughly for freight damage. If necessary,
contact your dealer/distributor immediately (your dealer/distributor must contact Aquatic, within 24 hours of receiving
unit to file a claim.) Should inspection indicate any damage, do not install the bath.
2. All baths are filled with water and operated in our manufacturing facility prior to shipment. Inspectors ensure watertight
operation, however, rough handling may cause leaks which may be detected prior to installation.
DAMAGE OR DEFECT TO THE FINISH CLAIMED AFTER THE BATH IS INSTALLED
To inspect:
1. Place the tub in an area where it may be drained after testing.
2. Fill the tub with water to the overflow and allow to stand for a few minutes. Carefully inspect all fittings and
connections for leaks. Should inspection indicate any damage, do not install the bath.
3. After connecting the (2) 240vac, 4 four wire circuits to junction boxes, run both pumps for 10 minutes and both
blowers for 10 minutes. With the pump running, turn on the blower. Check all functions. Inspect the tub completely.
Any defect must be reported to Aquatic prior to installation in order to have it covered by warranty. Should inspection
indicate any damage, contact Aquatic immediately.
4. Check to ensure that your installation will conform to all applicable codes and secure necessary permits. All electrical
and plumbing connections should be made by qualified electricians and plumbers.
DAMAGE OR LEAKS CLAIMED AFTER THE BATH IS INSTALLED ARE NOT COVERED UNDER THE WARRANTY.
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS DURING INSTALLATION
DO NOT MAKE ANY ALTERATIONS, ADDITIONS, OR DELETIONS TO THE
WARNING: Whirlpool blower, pump and piping are factory assembled. Relocation of blower, pump or other modifica-
tions could adversely affect the performance and safe operation of this air-whirlpool. Aquatic, shall not be liable under its
warranty or otherwise for personal injury or damage caused by any such unauthorized modification.
QUIETNESS OF OPERATION: Aquatic has engineered their air-whirlpool baths from base to lip to ensure quality, value,
functional design, and maximum bathing comfort. However, installation is accountable for as much as 50% of a tub's
operating quietness. Please ensure the following:
• The floor structure is adequate to support the installation.
• For quieter operation and heat retention conservation, the walls surrounding the air-whirlpool may be insulated.
• Insulate the tub surround. Do not allow any insulation to come within 3 feet of the blower and pump. The area
around the blower and pump must be clean and free of any foreign matter.
• Leave 1/8" to 3/16" gap between tub lip and surround.
8
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
IS NOT COVERED UNDER THE WARRANTY.
WILL RESULT IN TERMINATION OF THE WARRANTY:
Do not lift the tub by any portion of the plumbing or pump.
Do not stand in the tub during construction.
WHIRLPOOL SYSTEM, PUMP, BLOWER OR BATH.
Millennium Owner's Manual & Installation Guide
Aquatic
Hide quick links:
Advertisement
Table of Contents
