Table of Contents
Advertisement
Mounting the Control Knob
Mounting the Control Knob
1
Select Mounting Location
2
Install Battery
Use a coin to remove
the bottom cover.
3
Mount Control Knob Base
Orient the base so that the arrow is
Toward front of car
facing the front of the car.
You can either screw the base to
UP
the mounting location or use the
supplied adhesive pad.
If you use the adhesive pad, you
must FIRST CLEAN the surface with
the supplied alcohol cleaning pad.
Control Knob Button Operation
Control Knob Button Operation
Rotate outer ring to move the
highlight bar on the active screen
If Left or Right button is held for
2 seconds, outer ring becomes
Volume or Brightness adjustment
Press once for Back (Same as
Left button on Screen)
Press and hold for 2 seconds
to adjust Volume Up/Down
from outer ring
Press once for Center
menu bar item
Press and hold for 2
seconds to suspend
power or turn on
CR2032/DL2032
4
Attach Control
Knob to Base
Push the knob down onto the base,
and turn clockwise to lock it into place.
The knob can be removed by turning
the bottom counterclockwise.
Screen Dependent
Button Function
Press once for Source (Same
as Right button on Screen)
Press and hold for 2 seconds
to adjust Brightness from
outer ring
Press to select the
highlighted menu item
GPS-810NA
Advertisement
Table of Contents
Troubleshooting
